News
Yueqing Xinhong Electric Co., Ltd.
23
2024
-
02
Stainless steel armored cable sealing joint explosion-proof armored cable stuffing box
Author:
I. According to the wiring requirements of the distribution box, strip the outer sheath of the appropriate length of the cable to expose the metal armor. Kan Kan
2. Leave an appropriate length of armor to cut off the excess and dispose of the cable. Kan
3. Put the treated cable through parts 6 and 5 in sequence, and put the sealing ring in part 6 on the sheath of the cable,
1. 2.2.2.2.2.2.2.2.2.2.2.333333
4. The metal armor part is turned out through 4 to do the grounding treatment of the cable. Then, pass the core wire of the cable through 3 and 2 in sequence. Kan Kan
5. Mix the matching SG-100 two kinds of filler raw materials into the required filler, and then add the filler into the gap of the cable core wire and around the core wire to make its size close to the inner diameter of part 2, and add appropriate amount of filler into the cavity of part 3. Kan Kan
VI. Insert the cone of Part 3 into the armor and place Part 2 on Part 3. Kan
VII. Screw Part 1 to the inlet hole of the distribution box. Insert the cable through parts 2 to 6 into part 1 and screw part 5 onto part 1. In this way, the part 4 is pressed against the metal sheath and the cone of the part 3, and the part 2 is locked with the part 3. Kan Kan
8. Tighten Part 6 to Part 5 so that the seal ring in Part 6 is fastened to the outer sheath of the cable. Kan Kan
IX. After the packing box is installed, it should be ensured that the packing sleeve is filled with packing without bubbles, so as not to affect its performance. Kan
Note: Li Li. During threading operation, care should be taken not to damage the cable sheath. 2. Wipe the cable before filling, and the surplus filler on the parts after filling.
News
Message
Contact
No.38, Peisheng Road, Xiangbei Yishan Industrial Zone, Liushi Town, Yueqing City, Wenzhou City, Zhejiang Province